Eberspacher Easy Start Timer hysteresis programming

GeorgeRad

Senior Member
Joined
Mar 31, 2012
Posts
3,341
Location
Portland
Long shot question about Eberspacher Easy Start Timer hysteresis programming.

A couple of years ago I installed Eberspacher EasyStart Timer in lieu of DigiMax to control my Airtronics Espar D2 and Hydronic Espar D5. Main reason was to control both from one location.

Both units can be controlled, I gained faults readout for D5, but D2 control have very large temperature swings. Temperature display is about 4*F higher than ambient. Based on manual this higher temperature is related to the programmed hysteresis.

Easy Start Timer has programmable hysteresis with the range of 0-7*C with default set at 2*C. Unfortunately, my controller grayed these lines with dashes so I don’t know hysteresis set point.

My question is how to activate this option?
 

Attachments

  • 123.jpg
    123.jpg
    212 KB · Views: 27
  • GZR04041.jpg
    GZR04041.jpg
    331.4 KB · Views: 20
  • GZR04040.jpg
    GZR04040.jpg
    455.5 KB · Views: 23
  • Heater Timer - Eberspacher Easystart Timer - Installation Instruction Plus Altitude Kit and Diag.pdf
    920.4 KB · Views: 20

Try RV LIFE Pro Free for 7 Days

  • New Ad-Free experience on this RV LIFE Community.
  • Plan the best RV Safe travel with RV LIFE Trip Wizard.
  • Navigate with our RV Safe GPS mobile app.
  • and much more...
Try RV LIFE Pro Today
Back
Top