2010 Roadtrek 210 Versatile interior panel disassembly?

[Bender3455]

Hey all!

I'm trying to do some maintenance on my 2010 Roadtrek 210 Versatile. Namely, trying to fix a few water leaks that are leaking behind interior panels, as well as running some new wires for added electronics. I can't figure out how to get the panel under the Kool Cat heat pump out. There's water leaking directly onto it, and while I eventually plan to pull out the Kool Cat and reseal inside that cavity, I'd like to be able to remove the interior panel as well. I found the screws inside the deep side bins, but it's still holding on somehow. Does anyone have any tips or an assembly manual for the car, as I've been unable to find one. Thoughts?

 

[Bangorbob]

I'm watching this post. Hope someone passes on their knowledge.

 

[Johnnyfry]

Maybe a bit off topic, but you water leak could be due to a plugged drain hose from the CoolCat condensate pan. It is located on the passenger side rear just forward of the rear bumper. I have found mine plugged and blew it out with low pressure air. Debris flew out of the top end. My problem has not recurred but I suspect that a lot of stuff, leaves, etc, blow into the rear grille.

 

[topwop]

Can't help with removing the panel but a major leak in the coolkat area is the well nuts that hold down the roof cover. They are notorious for that and not that hard to replace. Here's a link to purchase the replacements, https://www.mcmaster.com/catalog/128/3647,
but you'll have to check for the exact size as I did mine a few years ago and don't remember, sorry.