Bob K4TAX's latest activity

I would start by disconnecting shore power. Then disconnecting the battery negative. Allow about 10 minutes or so and then reconnect...

I'd say, in a measure of cost and economy, they omitted a switch. I don't advise drilling a hole and adding a switch. One slip of the...

Please follow the procedure Larry-NC has provided. PROPER and complete flushing of the water system is mandatory. Until you get all...

That's very possible. Here in Houston, our pipes are in the attic. A visitor once tried running the water for 5 minutes to try to get...

Well, there is an electric heating element which my come out of position on the boiler. Could be low voltage of the 120 VAC type...

Thanks for noting that I should not go cheap on a break project :)

Since the toilet valve clogs, the problem is NOT in the water heater. Here is a flush technique that should do it. Take off all...

And have you ever drained the low-point drains without first setting the water heater bypass valves to the bypass state? NEVER DO THAT...

Are your bypass valves set properly?

I agree, replace the entire assembly. Much less expensive and all new parts. Don't nickel and dime the project to death. Search for...

The controller likely looks like the picture I've supplied. As to where it is located, about anybody's guess. Probably behind a blank...

The only true indicator of a propane tank contents is weight. The typically grill tank or 20 lb tank, when empty, is about 17 lbs...

Heat and moisture make the combination for mold growth. Open windows and vents to allow air to circulate. Bob

Push in wiring is garbage and prone to failure. Even a fire. Use only clamp in or screws.

Not really seeing any advantage to a single receptacle outlet box unless you a wanting to make sure you can't put anything else on that...